top of page

SUPERPROTECT BOILER PROTECT (PROTECTIVE COATING)

Product Data Sheet

  1. GENERAL PRODUCT DESCRIPTIONA High Temperature resistant paint formulation of a unique plate type structural composite which aligns itself to the surface to be protected to form a protective wall which is chemically inert, impervious to moisture, opaque to ultra violet rays and its resistant to salt air, acids, alkalies and fumes thereby protecting the surface from corrosion and chemical attack.CAUTION : Should be applied when Boiler surface is not hot.

  2. TECHNICAL SPECIFICATION

  3. Recommended ThinnerSUPERLUBE THINNER

  4. Flash Point (wet)82o F

  5. Viscosity in KU110

  6. Drying TimeTack free in 20 minutes

  7. Complete dry in One hour

  8. BrushabilityGood

  9. Weather Resistance( On steel) Good

  10. Water ResistanceGood

  11. Brine ResistanceGood

  12. ColourDark Grey

  13. Coverage100sq. ft. per litre

  14. TYPICAL USES

  15. Can be applied on boiler bodies to provide effective and long-lasting corrosion protection at elevated temperatures thereby extending the the life of the Boiler.

  16. ADVANTAGES

  17. Quick Drying. Tack free in 20 minutes and complete dry in 1   hour.

  18. Plate type structure aligns to the surface giving maximum   protection to the surface.

  19. Protective covering chemically insert and hence protects the   surface from corrosive chemicals, acids and fumes.

  20. Protective covering can withstand severe weathering and is not   affected by U.V. rays.

  21. Protective covering impervious to moisture and hence protects   surface from moisture & water.

  22. Binder resin has inbuilt flexibility to withstand severe   weathering.

  23. Coverage approx. 100 sq. ft. per litre.

  24. Most economical.

  25. APPLICATION

  26. CLEANING

  27. : Good surface preparation before the initial application is essential for adhesion and performance of SUPER PROTECT BOILER PAINT. Remove grease, oil, dust and dirt from the area to be coated and dry the surface before application.

  28. MIXING

  29. – Occasionally, as a result of storage a can will have some separation of clear solvent at the top. When this is noticed, force a rod through the paste to make holes to drain the solvent to the bottom, then stir thoroughly. If solvent evaporation occurs, thin with SUPERLUBE THINNER to desired consistency.

  30. APPLICATION

  31. – Can be applied by the brush, dip, roll, spray or flow. Coverage about 100 sq. ft. per litre. Drying time will vary with the thickness of the coating. In general coating will dry tack free in 20 minutes. To ensure complete drying allow about 1 hour.

  32. PACKING DETAILS

  33. PACKINGPRODUCT CODE

  34. 1 litre Tins – 4 per case110104

  35. 1 litre Tins – 16 per case110116

  36. 4 litre Tins – 4 per case110404

bottom of page