Product Data Sheet

  1. GENERAL PRODUCT DESCRIPTIONHigh purity solid lubricant of fine colloidal particles size of 0.44 mm. and below which can be used dry for very fine tolerances or to fortify oils and greases to provide effective and long-lasting lubrication in extreme temperatures, extreme pressures and corrosive conditions.


    Solid Content100%

    Density2.25 gm./cc.

    Youngs Modulas470 – 980 Kg./

    Electrical conductivity0.0395 – 0.0693

    Electrical resistance0.00283 (at 21o C)

    Hardness25-45 Hardness Selerescope Less than 1-2 Hardness Mohs scale

    Coefficient of linear  expansion at 17 C to 190 C0.04244

    Sublimation Temperature3650o C

    Vapourisation temperature4500o C

    Oxidation Temperature900o C

    Flash PointNone

    Freeze pointNone

    Particle size0.44 mm and below.

    Acid ResistanceVery good

    Brine ResistanceVery good

    Chemical ResistanceVery good

  3. TYPICAL USESUsed dry or as an additive to oils and greases for long life     applications to withstand extreme pressure and high     temperatures. Ideal as a lubricant and parting agent on pipe     joints, moulds, gaskets, gears, chains, packing etc. exposed     to air, alkali, gas, acid or brine.

  4. ADVANTAGESHigh purity SUPERLUBE provides unique lubricating     characteristics as it is unctuous, dry solid lubricant which     resists high temperatures, is a good conductor of heat and electricity and has a low coefficient of expansion.SUPERLUBE’s affinity for metal surfaces tends to result in     filling of the pores or small voids of the metal resulting in     smoother surfaces. Also its solid state allows it to withstand extreme pressures without being forced out of load     bearing surfaces. SUPERLUBE resists conditions that cause     failure of most lubricants namely high temperature, high     pressure and corrosive chemical conditions. As it is     chemically inert and is not affected by temperature and     pressure, it is an ideal parting agent for application on     pipe threads, gaskets and moulds. As it not wetted by molten   metals it is an ideal mould lubricant. Being chemically     inert it is ideal for applications in corrosive conditions.



    500 gms. Tins – 48 per case040548

    1 KG. Tins – 24 per case040124

    3 KG. Tins – 6 per case040306

    10 KG. Drums041000

    20 KG. Drums042000