Product Data Sheet

  1. GENERAL PRODUCT DESCRIPTIONHigh purity solid lubricant of finally powdered particles (size 95% below 0.074 mm.) which fill the pores and pits of the surfaces to provide effective and long lasting lubrication in extreme temperatures, extreme pressures and adverse chemical conditions.


    Solid Content100%

    Density2.25 gm./cc.

    Youngs Modulas470 – 980 Kg./

    Electrical conductivity0.0395 – 0.0693

    Electrical resistance0.00283 (at 21 C)

    Hardness25-45 Hardness Selerescope Less than 1-2 Hardness Mohs scale

    oefficient of linear  expansion at 17 C to 190 C0.04244

    Sublimation Temperature3650 C

     Vapourisation temperature4500 C

    Oxidation Temperature900 C

    Flash PointNone

    Freeze pointNone

    Particle size95% below 0.074 mm.

    Acid ResistanceVery good

    Brine ResistanceVery good

    Chemical ResistanceVery good

  3. TYPICAL USESUsed dry or as an additive to oils and greases for long life applications to withstand extreme pressure and high     temperatures. Ideal as a lubricant and parting agent on pipe joints, moulds, gaskets, gears, chains, packing etc. exposed     to air, alkali, gas, acid or brine.

  4. ADVANTAGESHigh purity SUPERLUBE provides unique lubricating     characteristics as it is unctuous, dry solid lubricant which     resists high temperatures, is a good conductor of heat and     electricity and has a low coefficient of expansion.SUPERLUBE’s affinity for metal surfaces tends to result in     filling of the pores or small voids of the metal resulting in     smoother surfaces. Also its solid state allows it to withstand extreme pressures without being forced out of load     bearing surfaces. SUPERLUBE resists conditions that cause     failure of most lubricants namely high temperature, high     pressure and corrosive chemical conditions. As it is     chemically inert and is not affected by temperature and     pressure, it is an ideal parting agent for application on     pipe threads, gaskets and moulds. As it not wetted by molten     metals it is an ideal mould lubricant. Being chemically     inert it is ideal for applications in corrosive conditions.



    50o gms. Tins – 48 per case030548

    1 KG. Tins – 24 per case030124

    3 KG. Tins – 6 per case030306

    10 KG. Drums031000

    20 KG. Drums032000